Reasons To Buy A Horizontal Machining Center

There are many reasons why you may want to find a Horizontal Machining Center. One of the most popular uses for a HMC is for milling die cast parts. They are so popular for this reason because of the ease with which they can be operated.

Horizontal Machining Center

The single biggest problem with milling die cast parts with the typical horizontal HMC is that you have to put the parts on a table. If you were to do it manually, it would take longer to turn out the part, and you’d be limited to using only one stroke per step. With a horizontal milling center, you could hold the machine at one end of the table, lift the parts to the other side of the table, and simply transfer the parts from one side to the other without being in any way limited by the setting on the table.

Another example would be for making custom parts. You could easily make several copies of a single part with an HMC. This means that you can have different versions for each item and also will keep the cost down considerably when compared to other methods. With a horizontal milling center, you won’t even need a separate blank.

While using a vertical machine can be very time consuming, using a horizontal milling center can often times take you less than five minutes. That is because you don’t have to put the parts in the machine and use up all your valuable time before you can get your work done.

It doesn’t have to be a complicated job to turn out a part like this. Most companies use machine shops for this, and they can set up the machines on wheels. As long as there is an outside door, a company can easily move the machine to the place where they need to finish the job.

One more reason why you may want to look into getting a Horizontal Machining Center is to create more jobs. In the past, it was possible to design and build only one machine to a design before it was difficult to complete other jobs.

A machine that can have multiple jobs will be much easier to operate. When you add it to the model, it will make it possible to take care of other parts of the design in parallel and save both time and money.

Comments have been closed/disabled for this content.